Hi folks, I have previously built SPLAT boxes running R55W and forced the interface duplex to 100mb/s, as with this example on a DL380G4:
options e1000.4.6.11 Duplex=2,2,2,2 Speed=100,100,100,100 options bcm5700 line_speed=100,100 full_duplex=1,1 auto_speed=0,0 However, I just tried the same thing on an identically configured DL380 running R55 (*not* R55W), and all the interfaces disappeared when it rebooted! I had to remove these lines from modules.conf to get the interfaces back again. Has anyone seen this before? Does it even make sense? I sure don't think so. Ed Luck -- Keep flying, and stay shiny. ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
