I am not sure whether this will work for you. I assume you are using Solaris
But do check whether you have a static route on your firewall box defined.
If you are using Solaris, then define your default router in the box.
Create a file called /etc/defaultrouter and enter the ip address of your
default router ( internet router)
Then add a route to your routing table that goes like:
route default defaultrouter
Also you might like to check out Lance' papers.
-----Original Message-----
From: Rusdyanto Tardjono [mailto:[EMAIL PROTECTED]]
Sent: 14 August 2000 09:45
To: [EMAIL PROTECTED]
Subject: [FW1] DMZ can't access to internet
Dear Guru,
I am in the process of Checkpoint pre-installation. As the requirement says,
I must make sure that the routing work before installing the software.
My configuration:
>From router goes into one NIC of FW-1 (202.xxx.xxx.xxx) and another NIC from
FW-1 goes into a hub which connects to DMZ Servers.
I can ping to internet from FW-1 machine but from a server in DMZ area can
only ping to the FW-1, not even ping to the router and internet.
Can someone please help me? Your advice is very much appreciated.
Thank you.
Regards,
Rusdy
============================================================================
====
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
============================================================================
====
================================================================================
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
================================================================================
