Dear Carlos,
Sorry that I forget to tell you that I'm using NT 4.0.
I have enabled the IP forwarding and the route from route print command in
NT seems fine.
Rusdy
-----Original Message-----
From: Carlos Infante [mailto:[EMAIL PROTECTED]]
Sent: Monday, August 14, 2000 4:10 PM
To: [EMAIL PROTECTED]
Subject: RE: [FW1] DMZ can't access to internet
Hi Rusdy,
Is de ip_forwarding = 1 in the FW1? Sometimes you need to set up in a script
in the boot process
(# "ndd set ip-forwarding=1" or something like that).
Has the FW1 the routes properly defined?
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]On Behalf Of
Rusdyanto Tardjono
Sent: lunes, 14 de agosto de 2000 9:45
To: [EMAIL PROTECTED]
Subject: [FW1] DMZ can't access to internet
Dear Guru,
I am in the process of Checkpoint pre-installation. As the requirement says,
I must make sure that the routing work before installing the software.
My configuration:
>From router goes into one NIC of FW-1 (202.xxx.xxx.xxx) and another NIC from
FW-1 goes into a hub which connects to DMZ Servers.
I can ping to internet from FW-1 machine but from a server in DMZ area can
only ping to the FW-1, not even ping to the router and internet.
Can someone please help me? Your advice is very much appreciated.
Thank you.
Regards,
Rusdy
============================================================================
====
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
============================================================================
====
================================================================================
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
================================================================================
