I ran a dual Xeon 3.06 setup for five years. I still have it but
don't use it. Just so you know, the CPUs run HOT and suck down
electricity like a wall heater, in fact you could use that box to
heat up a room in the winter.
w
At 01:22 PM 4/8/2010, you wrote:
I was worried about that potential, so I moved the motherboard back to the
original case. Hooked up the power supply and switch and still did not boot.
I added back the fans and found that it will only boot if 1 fan in each bank
is connected (There are a total of 5 fans, 2 for each CPU and on for other
"corridor" of the blade server).
These fans have 5 pin connectors. Is there a way to fool the motherboard
into thinking I have the fans connected? I am checking the web for potential
answers.
Thanks for the feedback.
Jim
> -----Original Message-----
> From: hardware-boun...@hardwaregroup.com
> [mailto:hardware-boun...@hardwaregroup.com] On Behalf Of JRS
> Sent: Thursday, April 08, 2010 1:10 PM
> To: hardware@hardwaregroup.com
> Subject: Re: [H] Problems with HP Proliant DL140
>
> check to make sure the new backplate is not touching the case.
>
>
> --
> J
>
> > The original cpu heatsink mounting
> > hardware connected directly to the
> > case bottom. The new heatsinks in the
> > new case required a backplate.
