or just check the power switch connector (from the front of the case) to
ensure it is on and has the right polarity...
On 2/12/2011 2:21 PM, [email protected] wrote:
Try bypassing the power switch on the case and just short it with a screwdriver
to see if it triggers power. Always test the board outside of the case to see
if it powers up in case of a grounding issue.
Sent via BlackBerry by AT&T
-----Original Message-----
From: "Bobby Heid"<[email protected]>
Sender: [email protected]
Date: Sat, 12 Feb 2011 14:19:56
To:<[email protected]>
Reply-To: [email protected]
Subject: [H] Hooked up everything, PC won't start
Hey,
I took my daughter's old m/b , cpu, psu, ram and all and was putting it into
another case to make a low powered server.
I have everything hooked up (I believe). The m/b power light glows, but
when I press the power button, nothing happens. No fans spin up or
anything.
Before I take it all apart to try again, does anyone have any suggestions on
what I could check or try?
BTW, I had asked earlier about putting on Windows Server 2008 R2. Turns out
I can't since this is a 32-bit P4. 2008 R2 is only 64-bit.
Thanks,
Bobby
