I tried shorting the pins where the switch connects and can sometimes make it power up. But then there is some alarm screaming at me. LOL.
I will check out the switch from Anthony's reply. If that does not fix it, I guess it's take it out and test and start all over. Thanks, Bobby -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of [email protected] Sent: Saturday, February 12, 2011 2:22 PM To: [email protected] Subject: Re: [H] Hooked up everything, PC won't start Try bypassing the power switch on the case and just short it with a screwdriver to see if it triggers power. Always test the board outside of the case to see if it powers up in case of a grounding issue. Sent via BlackBerry by AT&T -----Original Message----- From: "Bobby Heid" <[email protected]> Sender: [email protected] Date: Sat, 12 Feb 2011 14:19:56 To: <[email protected]> Reply-To: [email protected] Subject: [H] Hooked up everything, PC won't start Hey, I took my daughter's old m/b , cpu, psu, ram and all and was putting it into another case to make a low powered server. I have everything hooked up (I believe). The m/b power light glows, but when I press the power button, nothing happens. No fans spin up or anything. Before I take it all apart to try again, does anyone have any suggestions on what I could check or try? BTW, I had asked earlier about putting on Windows Server 2008 R2. Turns out I can't since this is a 32-bit P4. 2008 R2 is only 64-bit. Thanks, Bobby
