On 01/02/2014 03:14 PM, Beniamino Galvani wrote: > Hi, > On Tue, Dec 31, 2013 at 11:58:28AM -0500, Ján Veselý wrote: >>> While renaming arm926 UART driver to PL011, references to it must be >>> updated in the arm926 code to avoid to break compilation, but this >>> should be straightforward. >>> >>> This is what I did in the Raspberry branch (merge the two drivers and >>> replace references), and I also did some small modifications to the >>> driver to let it work on the Raspberry. I could not test if the arm926 >>> was still working after that due to lack of hardware. >> >> If I'm not mistaken the only ARM926 device we currently support is >> qemu integratorcp, it's included in the upstream qemu so testing >> should be straightforward. > > Thanks for the tip! I just tried with qemu and the uart on > integratorcp is working properly after the changes.
Hi Beniamino, I may have a completely silly question, but how do you install HelenOS on Raspberry Pi? I installed the latest Raspbian and changed it config.txt to contain: kernel=uimage.bin where uimage.bin is the u-boot image produced by our build system, but cannot get to a successful boot. Which is worse, I don't see any u-boot output either. Can you give some hint on how you work with it? Thanks, Jakub _______________________________________________ HelenOS-devel mailing list [email protected] http://lists.modry.cz/listinfo/helenos-devel
