Going back to the OP's question about finding the current
installation's command character to allow him to issue a
JES cancel by jobid command, would it be sufficient in a
JES3 environment to just extract any of the JES3 command
characters from a D OPDATA console command, since JES3
sites do not have to worry about running under poly-JES?
Thanks, -jack
----- Original Message -----
From: "Edward Jaffe" <[EMAIL PROTECTED]>
Newsgroups: bit.listserv.ibm-main
To: <IBM-MAIN@BAMA.UA.EDU>
Sent: Saturday, May 10, 2008 1:24 PM
Subject: Re: How to cancel with just the JES jobid?
Jack Schudel wrote:
Note that the z/OS 1.9 level of the manual does not show the
COMMAND_PREFIX= value, which may imply that it is not yet
available for JES3 sites. It has been available in JES2 since
z/OS 1.5.
I doubt IBM JES3 would ever populate this field to make it compatible
with JES2. JES2 command prefixes are always system-scoped. JES3 is
sysplex aware and allows up to seven sysplex-scoped prefixes and up to
seven system-scoped prefixes. Even if they chose to report those
prefixes via COMMAND_PREFIX= in SSI 54, the format would have to be
substantially different.
--
Edward E Jaffe
Phoenix Software International, Inc
5200 W Century Blvd, Suite 800
Los Angeles, CA 90045
310-338-0400 x318
[EMAIL PROTECTED]
http://www.phoenixsoftware.com/
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO
Search the archives at http://bama.ua.edu/archives/ibm-main.html
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO
Search the archives at http://bama.ua.edu/archives/ibm-main.html
