If you could help me understand. You posting shows CODE WAS 448
But in a later posting you say it is 16448 > IDC3003I FUNCTION TERMINATED. CONDITION CODE IS 0 IDC0002I IDCAMS > > PROCESSING COMPLETE. MAXIMUM CONDITION CODE WAS 448 There must be an issue with your cut and paste. Could you please post all messages from last command thru command with error? Please do not edit. Note: Review ALL messages in your output for the IDCAMS function step. The error could have occurred much earlier in your listing. Since you did not post the entire listing, I do not know where that error might be. IDC3003I is a general message. So look through the output from the entire IDCAMS step. See if there is a WAS xx which is NOT zero. If you have JES2/SDSF then SE the output. You can then X ALL; F ' CONDITION CODE IS ' ALL; x ' 0 ' all This may show you the errors. Lizette > -----Original Message----- > From: IBM Mainframe Discussion List [mailto:[email protected]] On > Behalf > Of Kayhan Tanriverir > Sent: Thursday, November 08, 2012 5:40 AM > To: [email protected] > Subject: Yan: VSAM data set list error > > Hi Lizette, > > > Yes, these are all the messages for this issue. > Yes, we have more than one command. > > Iyi calismalar, Saygilar / Regards > > Kayhan Tanriverir > Vizyon BT > Uzman Sistem Programcisi / Senior Systems Programmer (Please consider the > environment before printing this e-mail) > ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
