Which if there are no other errors, then an ETR/SR to IBM would be a good idea.
Lizette > -----Original Message----- > From: IBM Mainframe Discussion List [mailto:IBM-MAIN@LISTSERV.UA.EDU] On Behalf > Of David Elliot > Sent: Thursday, November 08, 2012 8:21 AM > To: IBM-MAIN@LISTSERV.UA.EDU > Subject: Re: VSAM data set list error > > This happened to me a while back. Intermittently I would see this from a LISTCAT > ENTRY(xx) command. The 448 is, I believe,the last three chars of > 16448 which is X'4040'. It was looking to me as though there was some corruption of > R15 at the end of the command. The command executed normally in my case and was > followed by the message below. > > Does your command execute, ie produce output? Does this happen on other files, is > this in batch or TSO? > > On Thu, Nov 8, 2012 at 8:57 AM, Lizette Koehler <stars...@mindspring.com>wrote: > > > If you could help me understand. > > > > You posting shows CODE WAS 448 > > > > But in a later posting you say it is 16448 > > > > > IDC3003I FUNCTION TERMINATED. CONDITION CODE IS 0 IDC0002I IDCAMS > > > > PROCESSING COMPLETE. MAXIMUM CONDITION CODE WAS 448 > > > > > > There must be an issue with your cut and paste. > > > > Could you please post all messages from last command thru command with > > error? Please do not edit. > > > > Note: Review ALL messages in your output for the IDCAMS function step. > > The error could have occurred much earlier in your listing. Since > > you did not post the entire listing, I do not know where that error might be. > > > > IDC3003I is a general message. So look through the output from the > > entire IDCAMS step. See if there is a WAS xx which is NOT zero. > > > > If you have JES2/SDSF then SE the output. You can then X ALL; F ' > > CONDITION CODE IS ' ALL; x ' 0 ' all > > > > This may show you the errors. > > > > Lizette > > > > > > > -----Original Message----- > > > From: IBM Mainframe Discussion List > > > [mailto:IBM-MAIN@LISTSERV.UA.EDU] > > On Behalf > > > Of Kayhan Tanriverir > > > Sent: Thursday, November 08, 2012 5:40 AM > > > To: IBM-MAIN@LISTSERV.UA.EDU > > > Subject: Yan: VSAM data set list error > > > > > > Hi Lizette, > > > > > > > > > Yes, these are all the messages for this issue. > > > Yes, we have more than one command. > > > > > > Iyi calismalar, Saygilar / Regards > > > > > > Kayhan Tanriverir > > > Vizyon BT > > > Uzman Sistem Programcisi / Senior Systems Programmer (Please > > > consider the environment before printing this e-mail) ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN
