Some Questions Is the LPAR this is running on, where the mount files reside?
For example, you only have one LPAR this can run on? Or is this a SYSPLEX and it can run on more than one system? If this is a sysplex, make sure the file mounted where the job runs. To do this, logon that that system and in ISPF using 3.17 (my favorite) enter the mount point. If it shows up, then enter FS next to any file/dir in that file. Ensure names and locations for the run are correct. Or you can go to SDSF and issue D OMVS,F,N= and the N= would be the actual MVS data set name. Look for where the file is mounted Or you could go into report from the SMP APPLY and review the DDDEF section. Make sure the mount point used by SMPE is the right mount point Note: This list typically will not allow attachments. So if you attached anything it may not go through. Lizette > -----Original Message----- > From: IBM Mainframe Discussion List [mailto:IBM-MAIN@LISTSERV.UA.EDU] On > Behalf Of Peter > Sent: Saturday, February 10, 2018 6:33 AM > To: IBM-MAIN@LISTSERV.UA.EDU > Subject: Apply error WAS product > > Hi > > While applying an FMID for the WAS V10 I received the below error > > Error Message: BPXF140E RETURN CODE 00000081, REASON CODE 0594003D. A LINK > FAILED FOR LINK NAME /usr/lpp/InstallationManagerRepository /HBBO850/IBM/.. > /WLP/fixpac. Pls find the attached log . > > I see a similar issue reported to IBM but for a different product > > http://www-01.ibm.com/support/docview.wss?uid=swg21195928 > > Has anyone faced this similar issue ? > > Peter > ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN
