I'm not sure why, but we have console devices that need a kick once in a while too, although ours are not ICC (something non-IBM). I figured it was their fault, but maybe not... You could open a PMR; might be easier for you with all IBM stuff in the mix.
Marcy "This message may contain confidential and/or privileged information. If you are not the addressee or authorized to receive this for the addressee, you must not use, copy, disclose, or take any action based on this message or any information herein. If you have received this message in error, please advise the sender immediately by reply e-mail and delete this message. Thank you for your cooperation." -----Original Message----- From: The IBM z/VM Operating System [mailto:ib...@listserv.uark.edu] On Behalf Of Martin, Terry R. (CMS/CTR) (CTR) Sent: Monday, July 20, 2009 10:29 AM To: IBMVM@LISTSERV.UARK.EDU Subject: Re: [IBMVM] Operator Console Thanks Marcy, I did what you suggested and it worked. Why do you think it made the difference? I would have thought since the device showed ENABLED that is was ready to go! Anyway thanks again! Thank You, Terry Martin Lockheed Martin - Information Technology z/OS & z/VM Systems - Performance and Tuning Cell - 443 632-4191 Work - 410 786-0386 terry.mar...@cms.hhs.gov -----Original Message----- From: The IBM z/VM Operating System [mailto:ib...@listserv.uark.edu] On Behalf Of Marcy Cortes Sent: Monday, July 20, 2009 12:13 PM To: IBMVM@LISTSERV.UARK.EDU Subject: Re: Operator Console Try: disable 36b vary off 36b vary on 36b enable 36b xautolog operator on 36b Marcy "This message may contain confidential and/or privileged information. If you are not the addressee or authorized to receive this for the addressee, you must not use, copy, disclose, or take any action based on this message or any information herein. If you have received this message in error, please advise the sender immediately by reply e-mail and delete this message. Thank you for your cooperation." ________________________________ From: The IBM z/VM Operating System [mailto:ib...@listserv.uark.edu] On Behalf Of Martin, Terry R. (CMS/CTR) (CTR) Sent: Sunday, July 19, 2009 3:50 PM To: IBMVM@LISTSERV.UARK.EDU Subject: [IBMVM] Operator Console Hi I have defined a ICC console (36B) I added this address in the System Config as the console and specify it on the LOAD parameter at IPL time. After the IPL operator was logged on to the ICC console without a problem. I decided to logon to Operator HERE at my desk so it took it away from 36B to me. Now I want to XAUTOLG OPERATOR ON 36B. When I try I get the following error message: HCPAUT051E GRAF 036B is not enabled I display the device 36b and it says it is enabled: q 36b GRAF 036B ENABLED Is this happening because I defined it as a console and I cannot XAUTOLOG Operator? Any help would be welcome. Thank You, Terry Martin Lockheed Martin - Information Technology z/OS & z/VM Systems - Performance and Tuning Cell - 443 632-4191 Work - 410 786-0386 terry.ma...@cms.hhs.gov