Jeff, Try
TAPE MODESET (3590B Or TAPE MODESET (3590C Then try to write to the tape again. Make sure you don't have the tape media write protect tab enabled. If you still get sense byte 6 = x'25' (media can be read only), then you may have to try another tape media. The tape media that you are trying to write to may have been written (iehinit) from a 9840C in 3490 mode. Mike -----Original Message----- From: The IBM z/VM Operating System [mailto:IBMVM@LISTSERV.UARK.EDU] On Behalf Of Jeff Gribbin Sent: Thursday, August 04, 2011 10:59 AM To: IBMVM@LISTSERV.UARK.EDU Subject: Re: HCPDPM1280E with STK 9840C Tape Drive Hmm - thanks for the hint ... >From OPERATOR ... HCPERP584I TAPE 0500 AN OPERATION WAS TERMINATED BECAUSE A HCPERP584I CAPABILITY CHECK OCCURRED HCPERP6300I SENSE DATA FORMAT = 04 MSG CODE = 01 HCPERP6301I CHANNEL COMMAND WORD COMMAND CODE = 01 HCPERP6303I SENSE = 804100D0 24202541 0001FF00 00000000 00000017 HCPERP6303I 17000090 40042301 68841310 HCPERP6304I IRB = 00C04017 6DF3D238 02001005 00800000 HCPERP6305I USERID = MAINT HCPERP2216I CHANNEL PATH ID = 50 HCPERP2220I PHYSICAL CHANNEL PATH ID = 0100 HCPERP2252I TAPE 0500 PATH 50 NOT OPERATIONAL HCPERP2252I TAPE 0500 PATH 50 NOT OPERATIONAL HCPERP602I TAPE 0500 AN INTERFACE CONTROL CHECK OCCURRED HCPERP6303I SENSE = 00000000 00000000 00000000 00000000 00000000 HCPERP6303I 00000000 00000000 00000000 At first reading, PATH 50 NOT OPERATIONAL is bizarre - given that this is the only path to the device and that the device happily comes online, accepts CP REWIND commands and allows all the kinds of read operations that I have tried so far. Given that it's a problem only ever reported here once - and that a long time ago - and that there must be several folk successfully using these drives every day, I'm leaning towards some kind of configuration problem but I'm not seeing it. (It's going to be obvious with hindsight - I just hope that hindsight comes soon!) For info, here's the IOCP stuff ... CHPID PATH=(CSS(0),50),SHARED, * PARTITION=((ZOSSSS,ZOS1,ZOS2,ZOS3MAST,ZVMIFL1),(=)), * PCHID=100,TYPE=FC CNTLUNIT CUNUMBR=C500,PATH=((CSS(0),50)),UNITADD=((00,016)), * UNIT=3590 IODEVICE ADDRESS=(500,001),CUNUMBR=(C500),STADET=Y,UNIT=3590 And here's what VM sees ... q 500 id 16:30:28 TAPE 0500 3590-10 CU: 3590-60 q path 500 17:01:04 Device 0500, Status ONLINE 17:01:04 CHPIDs to Device 0500 (PIM) : 50 17:01:04 Physically Available (PAM) : + 17:01:04 Online (LPM) : + 17:01:04 Legend + Yes - No q chpid 50 17:01:41 Path 50 online to devices 0500
