Hi there,
You need half duplex setting on Braille Lite. Further to this, if you
didn't choose to have a braille display when installing JAWS, you will need
to install again and, even if you did choose the BLT, if the BLT was not
turned on and connected to the computer, you will still need to re-install
JAWS. In addition, before starting your installation, use the AR-Chord+P
combination before starting the installation.
Hope this helps.
--
Carol Pearson
[EMAIL PROTECTED]
At 16:20 24/10/99 +1300, Vaughan Dodd wrote:
>Hi all.
>
>I'm attempting to get the bl2000 to run with the latest release of JFW as
>per JFW's installation of the Braille Lite as a braille display.
>
>Pc and Braille LIte agree on the serial port settings: 9600 with no parity,
>eight databits and one stop bit. The braille lite is set to half duplex
>and both have handshaking as xon-xoff. Braille lite is chorded into
>speechbox mode but i can't get JFW to send to the braille lite. Have tried
>speech turned off. Can't get any braille at all from the Braille LIte.
>
>Have tried JFW's braille display settings but as i'm moving into an area
>for me which is quite new i've eventually left the defaults presuming that
>they are most likely right.
>
>Any suggestions greatfuly appreciated and tried as they are received.
>
>Thanks.
>
>Vaughan.
>
>
>-
>Visit the jfw ml web page: http://jfw.cjb.net
>
-
Visit the jfw ml web page: http://jfw.cjb.net
