Hi Carol.
Well - it looks like the third attempt at a complete install of
v31.35. Can't remember whether the braille lite was turned on as described
when I ran the second install. Seems obvious to me but so far I am
unimpressed with the documentation on this matter from H.J. ar
Thanks.
Vaughan.
At 07:00 AM 10/25/99 , you wrote:
>Hi there,
>
>You need half duplex setting on Braille Lite. Further to this, if you
>didn't choose to have a braille display when installing JAWS, you will need
>to install again and, even if you did choose the BLT, if the BLT was not
>turned on and connected to the computer, you will still need to re-install
>JAWS. In addition, before starting your installation, use the AR-Chord+P
>combination before starting the installation.
>
>Hope this helps.
>
>
>--
>Carol Pearson
>[EMAIL PROTECTED]
>
>
>
>At 16:20 24/10/99 +1300, Vaughan Dodd wrote:
> >Hi all.
> >
> >I'm attempting to get the bl2000 to run with the latest release of JFW as
> >per JFW's installation of the Braille Lite as a braille display.
> >
> >Pc and Braille LIte agree on the serial port settings: 9600 with no parity,
> >eight databits and one stop bit. The braille lite is set to half duplex
> >and both have handshaking as xon-xoff. Braille lite is chorded into
> >speechbox mode but i can't get JFW to send to the braille lite. Have tried
> >speech turned off. Can't get any braille at all from the Braille LIte.
> >
> >Have tried JFW's braille display settings but as i'm moving into an area
> >for me which is quite new i've eventually left the defaults presuming that
> >they are most likely right.
> >
> >Any suggestions greatfuly appreciated and tried as they are received.
> >
> >Thanks.
> >
> >Vaughan.
> >
> >
> >-
> >Visit the jfw ml web page: http://jfw.cjb.net
> >
>
>-
>Visit the jfw ml web page: http://jfw.cjb.net
-
Visit the jfw ml web page: http://jfw.cjb.net
