I'm not sure how to go back and correct, but when you initially setup your Via parameters Dimensions->Tracks_and_Vias you can use the radio buttons to select which vias you're talking about, either Standard Via, Blind Via, or Burried Via.
Mike Sharkey Pike Aerospace Research Corporation www.pikeaero.com > Hi, > I am not sure that this is possible. Vias and through hole components > have pad for every layer. Try to edit the files with a Gerber editor and > trim the pads . Could you send a visual representation of the DRC ? Most > likely you will have to rework the problem zones. > Regards > > > On Fri, 2008-05-16 at 22:46 +0000, mkajdas wrote: >> My PCB house DRC check complains about vias having pads on inner >> layers. >> How to have via pads on the outside and no pads inside the board on 4 >> layer board? >> The inner pads are not connected to anything and do not hurt anything >> but I get over 500 errors that I want to clean up. >> Martin >> >> >> >> >> > >
