Hi,
I have similar problem. I am setting up Ldom Guest domain in Sun T1000 box.
Setup goes well, though when I install OS on guest domain using "boot vnet1 -
install", there is no further progress than just getting messages as below
Requesting Internet Address for 0:14:4f:fa:28:e1
At the Jumpstart server the rarp messages are as below
/usr/sbin/in.rarpd:[3] RARP_REQUEST for 0:14:4f:fa:28:e1
/usr/sbin/in.rarpd:[3] trying physical netnum 192.168.10.0 mask ffffff00
/usr/sbin/in.rarpd:[3] good lookup, maps to 192.168.10.177
/usr/sbin/in.rarpd:[3] immediate reply sent
I have gone through all pointers where its mentioned that vsw0 ethernet id
should be the same as primary interface ethernet id. Also when I try doing ssh
to this IP from any other machine on the same subnet, I am able to get in.
Below are ldm config details...
NAME STATE FLAGS CONS VCPU MEMORY UTIL UPTIME
primary active -t-cv SP 4 2G 0.1% 12h 58m
SOFTSTATE
Openboot initializing
VCPU
VID PID UTIL STRAND
0 0 0.4% 100%
1 1 0.2% 100%
2 2 0.0% 100%
3 3 0.0% 100%
MAU
CPUSET
(0, 1, 2, 3)
MEMORY
RA PA SIZE
0x8000000 0x8000000 2G
IO
DEVICE PSEUDONYM OPTIONS
pci at 780 bus_a
pci at 7c0 bus_b
VDS
NAME VOLUME OPTIONS DEVICE
primary-vds0 vol1 /LDOM1
VCC
NAME PORT-RANGE
primary-vcc0 5000-5100
VSW
NAME MAC NET-DEV DEVICE MODE
primary-vsw0 00:14:4f:21:55:60 bge0 switch at 0 prog,promisc
VCONS
NAME SERVICE PORT
SP
------------------------------------------------------------------------------
NAME STATE FLAGS CONS VCPU MEMORY UTIL UPTIME
ldg1 active -t--- 5000 4 1G 0.0% 18m
SOFTSTATE
Openboot initializing
VCPU
VID PID UTIL STRAND
0 4 100% 100%
1 5 0.0% 100%
2 6 0.0% 100%
3 7 0.0% 100%
MEMORY
RA PA SIZE
0x8000000 0x88000000 1G
VARIABLES
auto-boot?=false
boot-device=vdisk
local-mac-address?=true
NETWORK
NAME SERVICE DEVICE MAC
vnet1 primary-vsw0 at primary network at 0
00:14:4f:fa:28:e1
DISK
NAME VOLUME TOUT DEVICE SERVER
vdisk1 vol1 at primary-vds0 disk at 0 primary
VCONS
NAME SERVICE PORT
ldg1 primary-vcc0 at primary 5000
--
This message was posted from opensolaris.org
