> Hi folks (and Troy, too), > I'm actually trying to connect a VPN tunnel through an existing network, > but because I want ALL traffic to flow from one subnet...through the > existing network...and on to the other subnet, I'm not sure if this is a > bridge question/problem for the group or just a regular VPN > question/problem. I tend to think that the result I'm looking for > *seems* like a bridging scenario, but because I also want the traffic to > be encrypted, I'm not sure where to start. Anyway, that's what I'm > trying to achieve. For reference, check out my previous posting entitled > "Bering VPN questions-School project". Thank you.
This is a VPN problem, not a bridging problem. What you basically need to do is replace the default route on your system with a route through your VPN tunnel. There are a couple of practical problems you can run into when doing this, but it is quite possible. There's a fair amount of documetnation about setups like this in the FreeS/WAN docs, and in their mailing list archives...you basically need to setup a tunnel with the far end being 0/0 (the whole internet), and the near end being your existing network. NOTE: There's another feature that you may find handy...look through the FreeS/WAN documentation for "extruded subnet" configurations. This allows your remote systems to behave as if they were on a subnet located at the far end of your VPN. Charles Steinkuehler http://lrp.steinkuehler.net http://c0wz.steinkuehler.net (lrp.c0wz.com mirror) ------------------------------------------------------- This sf.net email is sponsored by:ThinkGeek Welcome to geek heaven. http://thinkgeek.com/sf ------------------------------------------------------------------------ leaf-user mailing list: [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/leaf-user SR FAQ: http://leaf-project.org/pub/doc/docmanager/docid_1891.html
