Hello Dexter.
Very nice job on that stand,.that is something to be proud of. You did a
very nice job on it. I did not see any top pictures did you add any groves
or details on that as well?
Have a good night.
C.A.G.
----- Original Message -----
From: "Dexter Bland" <dexterbl...@gmail.com>
To: "legacy-ornamental-mills" <legacy-ornamental-mills@googlegroups.com>
Sent: Thursday, May 31, 2012 7:17 PM
Subject: Podium Project
The legs are attached with a dovetail joint. I cut the groove with the
legacy. As has been discussed here before, this machine is not really
that good at doing dovetail joints. Really, most of the slop in
movement was from the plunge legs of the router. I cut the leg part of
the dovetail joint with a router table and had to cut them to fit one
at a time since the grooves were not exactly the same size. I did put
screws in from the bottom to pin the legs so they wouldn't move while
the glue dried.
--
Dexter Bland
"All that is necessary for the triumph of evil is for good men to do
nothing." Edmund Burke
--
You received this message because you are subscribed to the Google Groups
"Legacy Ornamental Mills" group.
To post to this group, send email to
legacy-ornamental-mills@googlegroups.com.
To unsubscribe from this group, send email to
legacy-ornamental-mills+unsubscr...@googlegroups.com.
For more options, visit this group at
http://groups.google.com/group/legacy-ornamental-mills?hl=en.
--
You received this message because you are subscribed to the Google Groups "Legacy
Ornamental Mills" group.
To post to this group, send email to legacy-ornamental-mills@googlegroups.com.
To unsubscribe from this group, send email to
legacy-ornamental-mills+unsubscr...@googlegroups.com.
For more options, visit this group at
http://groups.google.com/group/legacy-ornamental-mills?hl=en.
