Hello, I'm using the soundlevel function to control the overall volume of a Director project. I have a slider which changes the soundlevel according to its position. On a MAC this is giving me good linear volume control, but on a PC I am having a problem. At soundlevel 0 the volume is mute but when I move it to 1 the volume goes high immediately and then hardly changes as I up the soundlevel from 1 to 7.
Also I am using quicktime movies and the soundlevel function is having no effect at all on the volume of any quicktime sprites. With the soundlevel = 0 the quicktime sprites are still playing a full volume. If I directly write the volume of the specific quicktime sprite this works and I can lower the volume. Again this is only a problem on PC's. Any ideas? I do need to use the soundlevel command because the project uses all 8 soundchannels and much of the sound is interactive. thanks, Dave. [To remove yourself from this list, or to change to digest mode, go to http://www.penworks.com/lingo-l.cgi To post messages to the list, email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED]). Lingo-L is for learning and helping with programming Lingo. Thanks!]
