I'm serious about this being fun. I enjoy learning/making new things even when they are sometimes frustrating like just finding out that the LVM command line interface isn't working on this new install I just did!
Bobby Bauer Center for Information Technology National Institutes of Health Bethesda, MD 20892-5628 301-594-7474 -----Original Message----- From: Mark Post [mailto:[EMAIL PROTECTED] Sent: Friday, August 31, 2007 1:22 PM To: LINUX-390@VM.MARIST.EDU Subject: Re: Adding dasd with Red Hat >>> On Fri, Aug 31, 2007 at 12:47 PM, in message <[EMAIL PROTECTED]>, "Bauer, Bobby (NIH/CIT) [E]" <[EMAIL PROTECTED]> wrote: > Very close. > > The dasd= parm is in /etc/modprobe.conf, not /etc/zipl.conf. Rats. Ok, I'll try to remember that. -snip- > New dasd online and I'm reading about LVM. > Haven't had this much fun since I learned the IBM firewall technologies > a couple of years ago! Not sure if you were being sarcastic or serious, but I've had more fun in the last seven years than I had for quite a while before that. :) Mark Post ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390