> (There are a number of solutions to the size problem, if that is indeed the culprit
>here. The easiest is just to increase your use of modularization when you build your
>kernel, but you can also just adjust the partition map for your flash parts in
>bootldr/btflash.c, taking care to perform the corresponding update in the kernel MTD
>drivers, if you use them.)
I am pretty sure that the size is the problem ... I tried flashing a
smaller file (not a kernel) and it worked fine. Currently, I am at
about a 640K zImage with the standard "make assabet_config" on the 2.4.1
kernel. I don't think that I can take much out of there (or modularize)
without influencing the usability of the kernel, especially not to dump
100K.
So, does JD's patch on www.wearablegroup.org work with the newest
bootldr from handhelds.org, or should I use the november version with
which it was developed?
-Mike
_______________________________________________
http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm
Please visit the above address for information on this list.
