On Mon, 20 Nov 2000, Robert Collier wrote:
> Well, I had to use irattach with un-patched -test10 before I could see
> my phone (motorola L7389) as an IrCOMM device.
>
> I tried what you suggested, and the driver loaded and obtained a
> hw-address on the irda0 interface, however when I tried to use
> irobex_palm3 to send a file I had the following:
>
> irlap_change_speed(), setting speed to 9600
> Assertion failed! hashbin != NULL,irqueue.c,hashbin_insert,line=220
> Assertion failed! irlmp != NULL,irlmp.c,irlmp_register_link,line=263
I haven't seen these messages. For me, IrCOMM to my phone (Ericsson
A1018s) works fine after doing _only_ these commands (kernels 2.4.0test5,
2.4.0test7, 2.4.0test11pre3):
modprobe nsc-ircc dongle_id=9
ifconfig irda0 up
modprobe ircomm-tty
Although I get tons of warnings about ircomm already registered from
devfs. I assume a %d is missing somewhere, as I only get a /dev/ircomm and
no ircomm[0-9]*.
It has been a long time since I tested OBEX, though. I'll have a look at
it (probably tomorrow).
_______________________________________________
Linux-IrDA mailing list - [EMAIL PROTECTED]
http://www.pasta.cs.UiT.No/mailman/listinfo/linux-irda
