On 09/03/21 12:24, Andy Shevchenko wrote:
> Rearrange optional stuff in pps_gpio_setup() so it will go after mandatory one
> and with reduced indentation. This will increase readability of the sources.
> 
> Signed-off-by: Andy Shevchenko <andriy.shevche...@linux.intel.com>
> ---
>  drivers/pps/clients/pps-gpio.c | 33 ++++++++++++++++++---------------
>  1 file changed, 18 insertions(+), 15 deletions(-)
> 
> diff --git a/drivers/pps/clients/pps-gpio.c b/drivers/pps/clients/pps-gpio.c
> index b097da5a659a..35799e6401c9 100644
> --- a/drivers/pps/clients/pps-gpio.c
> +++ b/drivers/pps/clients/pps-gpio.c
> @@ -110,28 +110,31 @@ static int pps_gpio_setup(struct device *dev)
>               return dev_err_probe(dev, PTR_ERR(data->gpio_pin),
>                                    "failed to request PPS GPIO\n");
>  
> +     data->assert_falling_edge =
> +             device_property_read_bool(dev, "assert-falling-edge");
> +
>       data->echo_pin = devm_gpiod_get_optional(dev, "echo", GPIOD_OUT_LOW);
>       if (IS_ERR(data->echo_pin))
>               return dev_err_probe(dev, PTR_ERR(data->echo_pin),
>                                    "failed to request ECHO GPIO\n");
>  
> -     if (data->echo_pin) {
> -             ret = device_property_read_u32(dev, "echo-active-ms", &value);
> -             if (ret) {
> -                     dev_err(dev, "failed to get echo-active-ms from FW\n");
> -                     return ret;
> -             }
> -             data->echo_active_ms = value;
> -             /* sanity check on echo_active_ms */
> -             if (!data->echo_active_ms || data->echo_active_ms > 999) {
> -                     dev_err(dev, "echo-active-ms: %u - bad value from FW\n",
> -                             data->echo_active_ms);
> -                     return -EINVAL;
> -             }
> +     if (!data->echo_pin)
> +             return 0;
> +
> +     ret = device_property_read_u32(dev, "echo-active-ms", &value);
> +     if (ret) {
> +             dev_err(dev, "failed to get echo-active-ms from FW\n");
> +             return ret;
>       }
>  
> -     data->assert_falling_edge =
> -             device_property_read_bool(dev, "assert-falling-edge");
> +     /* sanity check on echo_active_ms */
> +     if (!value || value > 999) {
> +             dev_err(dev, "echo-active-ms: %u - bad value from FW\n", value);
> +             return -EINVAL;
> +     }
> +
> +     data->echo_active_ms = value;
> +
>       return 0;
>  }
>  
> 

Acked-by: Rodolfo Giometti <giome...@enneenne.com>

-- 
GNU/Linux Solutions                  e-mail: giome...@enneenne.com
Linux Device Driver                          giome...@linux.it
Embedded Systems                     phone:  +39 349 2432127
UNIX programming                     skype:  rodolfo.giometti

Reply via email to