On 03/30/2014 01:26 PM, Ian Campbell wrote:
On Sun, 2014-03-30 at 12:58 +0200, Olliver Schinagl wrote:
4271202 sunxi: add board hcore hc860
seems to be un-able to extract the tar-ball and causes an oops.
That's from ages ago, isn't it?
It is! I will now use the u-boot from even older; that came with
fedora19, very conservative, but also 'known to be somewhat good'
Are you sure it isn't some other component which has changed recently,
e.g. the kernel?
Software wise, i'm running it quite conservative really, really old
stuff so to say.
That said the sorts of random crashed you've been posting sound a lot
like either a DRAM issue or overheating. Either of which could be down
to u-boot setting up something wrong or bad hardware I suppose.
Overheating, maybe. It feels hottish to the touch, but can hold a finger
on it without any problem whatsoever. Not close to the pain point. So I
estimate < 50 C? Shouldn't be reason to be concerned imo.
Power might be the problem, i see the input voltage under heavy load
drop to 4.65 Volts @ 0.9 amps
This is on an SSD, with a 2amps charger. I ran tinymembenches before
never exceeding 0.7 amps; could someone confirm this on the cubietruck?
I've just FEL booted with 2014.04-rc2-00665-g96510e1 (i.e. current
u-boot-sunxi.git#sunxi) onto a SATA installation and have started a git
clone of the kernel, after which I'll run a build and see what happens.
Cool, the strange thing is, u-boot cloned and compiled fine :(
Have you checked the checksum of the tarball you are extracting and
tried unpacking it on a known good system?
The sha1sum matches, calculated on the board, so that's good. xz -d
completed successfully!
tar xvf fails however, with a big ass 5 page long oops.
Olliver
Ian.
--
You received this message because you are subscribed to the Google Groups
"linux-sunxi" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to linux-sunxi+unsubscr...@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.
