I have installed an Agfa SnapScan 600 scanner via a Tecmar SCSI card.
The scanner is hooked up correctly (termination is correct). The
scanner shows up and, scanimage will list it when asked to list
devices.
However, when I try to scan, the scan bar (or whatever it is called) in
the scanner will move some 20% of the way and then stop. In xscanimage,
if I am doing a preview, I will see as much as the bar moved to. I can
then scan no more nor start another scan.
I have followed the steps in the SxS.
The scanner is all that is connected to the SCSI card.
I do not see any messages in the system log file.
Aside from suggesting that the scanner is broken, any suggestions?
--
=====================================================================
Roger Oberholtzer E-mail: [EMAIL PROTECTED]
OPQ Systems AB WWW: http://www.opq.se
Erik Dahlbergsgatan 41-43 Phone: Int + 46 8 314223
115 32 Stockholm Mobile: Int + 46 733 621657
Sweden Fax: Int + 46 8 302602
_______________________________________________
http://linux.nf -- [EMAIL PROTECTED]
Archives, Subscribe, Unsubscribe, Digest, Etc
->http://linux.nf/mailman/listinfo/linux-users
