Does it fail even if you go for a text based install ? In which case you can install and then do the X config later after the install
On 9/3/06, Francis Musinguzi <[EMAIL PROTECTED]> wrote:
EBM, How did U manage to install the Linux on the Dell Latitude D600. I tried a couple of RedHat based distros with no success. Is it a general prob, or a vga prob. The installer (anaconda) always failed to detect the monitor type FRANCIS. ======================================================================== Ernest, B.M (AfriNIC - ZA) writes: > [EMAIL PROTECTED] wrote the following on 08/19/2006 07:14 PM: > > [...] > >> However with the onboard dell card, Yast has the correct IP >> settings but the card is not able to pick them up > > i had a (quite) similar prob with 9.3 on my laptoy. using ifconfig > worked fine, using the yast TUI (run from the shell) gave problems > like your have, and using the yast GUI worked well. > > (this was a broadcom card, on-board a dell latitude d600) > > funny. > > ebm _______________________________________________ LUG mailing list [email protected] http://kym.net/mailman/listinfo/lug %LUG is generously hosted by INFOCOM http://www.infocom.co.ug/ The above comments and data are owned by whoever posted them (including attachments if any). The List's Host is not responsible for them in any way. ---------------------------------------
-- AC KISSA B.Sc Info Tech RHCE (804005213917312) | LPIC-1 | LPIC-2 (LPI000074540) To follow the path, look to the master, follow the master, walk with the master, see through the master, become the master. (zen) _______________________________________________ LUG mailing list [email protected] http://kym.net/mailman/listinfo/lug %LUG is generously hosted by INFOCOM http://www.infocom.co.ug/ The above comments and data are owned by whoever posted them (including attachments if any). The List's Host is not responsible for them in any way. ---------------------------------------
