hah thanks. In case it's useful, I have one m100 where the display was flickering and wouldn't go all the way dark, and I fixed it by spraying the contrast pot with deoxit d5. It took a solid couple weeks for it to fully dry out and work right again. During that time it was super faint and even totally blank for several days. But after it finally did dry out it's been perfect since then.
But the rest of the machine wasn't crashing so you might be on to something with the caps in your case. I pretty much knew it was the pot because you can sort of see the visual version of a scratchy volume knob. -- bkw On Fri, Mar 16, 2018, 9:04 PM Chris Kmiec <ckmi...@gmail.com> wrote: > Brian, that DVI Wiki is awesome, thank you. I've ordered some > gender-changer male pin headers, so next weekend I should have a working > 102 setup. > > On a side note, LCD on the 100 that came with the DVI has started > flickering and dimming, but the computer itself has also started crashing, > after using for a bit. I think I'll go through all the caps and replace > them, and clean the LCD connectors. > > On Fri, Mar 16, 2018 at 10:58 AM, Mike Stein <mhs.st...@gmail.com> wrote: > >> That's a possibility, but as far as I can tell no combination of what >> Chris has would work with a 102/200. >> >> m >> >> ----- Original Message ----- >> *From:* Brian White <bw.al...@gmail.com> >> *To:* m...@bitchin100.com >> *Sent:* Friday, March 16, 2018 9:49 AM >> *Subject:* Re: [M100] DVI cable for 102 >> >> Probably someone ends up with 3 cables because probably a single long, >> 100-only cable (and a 100-only system disk) came with the DVI, and the two >> short ones came later with the 100/200 system disk. >> >> >> >> >
