g`day,
this motor had an A cam in it when i bought it and 33mm ports i put the
su`s on and it was running nice like that but i thought id portmatch the
manifold and try a few cams i got here. i just thought id start with the C,
ill try a 25/65 .470lift cam next then maybe the B if i dont do somthin else
instead by then.
What specs are the cam you got ?
i got it running and it idled nice and smooth when it fired up, i had to
richen it a full turn from what it was set at to get it to revv, coz it just
wouldnt go over about 1200, and then it run sweet havent give it a good run
yet as its got a overheating prob ill figure out in the morn i hope.
it had a noticble difference and it was nice and responsive above about
1500rpm but didnt feel real powerful round the back yard. ill get into it
again tomorrow and give it a proper tune up, seems not too bad like it is
tho.
Paddy
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.datascribe.com.au/ozdatonline/index.htm
http://www.datascribe.com.au/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
