hi, yeah, its not bad is it?, i`m getting another block cast with 3 inch thick bores, annd a titanium alloy head, and pistons, and a couple of bic biro tubes for conrods............................
actually, someone mentioned that wurth had some MOTOR SEAL gasket stuff in a tube, to use on head gaskets, and it says that the temp rating is -50c to +250c and resistant to pressure up to 600 BAR!!!!!!!!!!! any way what are u doing up so late? its about 25 past 3 s.a. time....... mark k ----- Original Message ----- From: "Daniel Kroehn" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Saturday, February 23, 2002 1:23 AM Subject: Re: a few things > 600 bar = 8700 psi. ( 1 bar = 14.5 psi ) > That's a fair bit of boost from an ol' T3 ;-) > > Daniel Kroehn > > ----- Original Message ----- > From: "mark krawczuk" <[EMAIL PROTECTED]> > To: <[EMAIL PROTECTED]> > Sent: Saturday, February 23, 2002 12:30 AM > Subject: a few things > > > > hi, does any body have a good ego sensor, nissan type with a single > green > > wire? the one i`m after should screw into a t3/nissan FJ 20 turbo... > > email me :[EMAIL PROTECTED] if u have > > > > what is the equivalent pound pressure for 600 bar? > > > > > > also , what does PING mean? i noticed it a few times, on WINMX... > > > > MARK K > > > > --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[email protected]/ ---------------------------------------------------------------------
