what else would a datto owner be doing this time in the morning if his car
wasn't on the road?

Daniel Kroehn

----- Original Message -----
From: "mark krawczuk" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Saturday, February 23, 2002 3:04 AM
Subject: Re: a few things


> hi,    yeah, its not bad is it?, i`m getting another block cast with 3
inch
> thick bores, annd  a titanium alloy head, and pistons,  and a couple of
bic
> biro tubes for conrods............................
>
>
> actually, someone mentioned  that wurth had some  MOTOR SEAL gasket stuff
in
> a tube,  to use on head gaskets, and it says  that  the temp rating
is -50c
> to +250c  and resistant to pressure up to  600 BAR!!!!!!!!!!!
>
>
> any way what are u doing up so late? its about  25 past 3 s.a. time.......
>
>
>
>  mark k
> ----- Original Message -----
> From: "Daniel Kroehn" <[EMAIL PROTECTED]>
> To: <[EMAIL PROTECTED]>
> Sent: Saturday, February 23, 2002 1:23 AM
> Subject: Re: a few things
>
>
> > 600 bar =  8700 psi.  ( 1 bar = 14.5 psi )
> > That's a fair bit of boost from an ol' T3  ;-)
> >
> > Daniel Kroehn
> >
> > ----- Original Message -----
> > From: "mark krawczuk" <[EMAIL PROTECTED]>
> > To: <[EMAIL PROTECTED]>
> > Sent: Saturday, February 23, 2002 12:30 AM
> > Subject: a few things
> >
> >
> > > hi,  does any body have  a good ego sensor, nissan type with a single
> > green
> > > wire? the one i`m after   should  screw into a    t3/nissan FJ 20
> turbo...
> > > email me :[EMAIL PROTECTED] if u have
> > >
> > >  what is the equivalent  pound pressure  for 600 bar?
> > >
> > >
> > > also ,  what does PING mean? i noticed it a few times, on  WINMX...
> > >
> > >            MARK K
> > >
> >
> >
>

--membersozdat-------------------------------------------------------
OZDAT Mailing List   Please Note:-
Send (un)subscribe requests to  [EMAIL PROTECTED]
Send  submissions to  [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------

Reply via email to