Chris, That combination sounds quite feasible. Jetting can vary quite a lot depending on porting, cam and valve sizes but what you have would be a good start.
Cheers Feral Errol -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Chris King Sent: Sunday, 26 May 2002 6:38 PM To: [EMAIL PROTECTED] Subject: twin webber settings Hey guys, Ive got an L20 with extractors and twin webbers, not sure about the cam, ive been told its an Ivan tie (?) works 72 deg cam. 34 - 74 --- 35 - 655 495 valve lift XO - XC - IO - IC The engine seems to make power from about 2.5 - 5.5k. does this sound about right for this cam? Also i thought i would check out my webbers and see what kind of settings they had. Carby: 2x 45 DCOE 13 chokes: 36 Aux vent: couldn't get out. Main jet: 150 emulsion tube: F15 Air corrector: 160 idle jet: 50 F9 acc pump jet: 50 haven't opened them up so dont know needle valves etc. Do these specs sound about right?Is there anything in the carbys that would be holding it back from 6.5 - 7k? Thanks for your help Chris King. --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[email protected]/ ---------------------------------------------------------------------
