Harry,
It sounds like you are driving a sand point. It won't get much water
in clay. It is made to take up water in sand or gravel layers. BTW,
I lived at the top of a 100' hill, but water was about 7' down. THe
basement got water in every appreciable rain.
Max
Thanks, this is the kind of information I need. I'm not sure how
I'll get samples through the screens of the drill point. I know
silt gets through and that may tell the tale. I also think when I
hit sand, there will be a sound change from the cement mixer driving
activity and quicker movement downward.
After this next section of pipe gets down, I'll try to flush up some
samples. Even if its still just clay now, I'll know it can be done.
I'll dry and save the samples in zip bags and watch for changes.
Thanks
Harry
When I had an irrigation well drilled, a two-man crew with portable
drilling rig did the job. As the rig drove the well point down, it used
water under pressure to lubricate the point, and most of that water came
back up out of the whole, carrying material from the bottom of the well.
When that material included ancient sea shells, they would stop drilling
and test the well to see if it would produce water. The rest of the
time the material was mostly clay and sand.
I would say that if you can force water down the pipe and then examine
what flows back out, watch for a change in material (i.e. from clay to
sand or gravel or shells) and when you see a change, stop and test to
see if you can produce water from the well. The crew I hired had a
gasoline powered pump to apply suction to the well pipe to try to pull
water out.
My well went down to about 70 feet, but the 1 hp pump sucking on the top
of the pipe could not produce too much volume - about enough water to
run one sprinkler head. Driller pulled the pipe back up to about 40
feet, and then we got enough water to run three maybe four sprinkler
heads, and called that good.
Ten years ago that cost me about $500 for the drilling and about $300
for the pump and pipe and valves.
-Max
-----Original Message-----
From: mercedes-boun...@okiebenz.com
[mailto:mercedes-boun...@okiebenz.com] On Behalf Of harry watkins
Sent: Sunday, November 07, 2010 9:39 PM
To: Mercedes Discussion List
Subject: [MBZ] OT DIY water well
I am driving a well through my basement floor in the hopes of being able
to reach good water.
I have rookie questions because I'm a rookie. If any of you have
knowledge or experience, tell me what to look for that will give a clue
that water is close. My house is built into a red clay hill and the
first 17 feet have been through clay.
Thanks
Harry
86 300 SDL
_______________________________________
http://www.okiebenz.com
For new and used parts go to www.okiebenz.com To search list archives
http://www.okiebenz.com/archive/
To Unsubscribe or change delivery options go to:
http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
_______________________________________
http://www.okiebenz.com
For new and used parts go to www.okiebenz.com
To search list archives http://www.okiebenz.com/archive/
To Unsubscribe or change delivery options go to:
http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
_______________________________________
http://www.okiebenz.com
For new and used parts go to www.okiebenz.com
To search list archives http://www.okiebenz.com/archive/
To Unsubscribe or change delivery options go to:
http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
_______________________________________
http://www.okiebenz.com
For new and used parts go to www.okiebenz.com
To search list archives http://www.okiebenz.com/archive/
To Unsubscribe or change delivery options go to:
http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com