Based upon your recent video of the snowblower use, it appears that your
house is not very far from the garage. If you have the electrical
capacity in the house, then put a big plug on the side of the house and
use a heavy duty cord intended for the pupose to extend over to the
garage or the driveway.
When I was a youngster, my father would weld out in the garage and the
lights in the house would dim and the radio or tv would buzz along with
the welder.
I think the whole place was on a 60 Amp service.
RB
On 10/02/2015 3:20 PM, Curt Raymond via Mercedes wrote:
Of course, but I'd need bigger power too. I've got 1 20a circuit to the
garage...
Someday when I build an addition on the garage I'll get a sub panel out there
with 220v service. Then a bigger compressor and welder...
For now if I need more heat I'll take it somewhere or get an AC buzz box stick
welder. That'll do more penetration than a mig would anyway.
-Curt
From: Randy Bennell <[email protected]>
To: Curt Raymond <[email protected]>; Mercedes Discussion List
<[email protected]>
Sent: Tuesday, February 10, 2015 3:44 PM
Subject: Re: [MBZ] secret message to Curt
On 10/02/2015 12:15 PM, Curt Raymond via Mercedes wrote:
I haven't left the yard in the recent batch (ie yesterday) but I went out Sunday on a
pirate run. Had to break some trail which is always exciting through 8" of powder.
We tried to go out yesterday but the roads were so slippery I managed to get the trailer
sideways making a turn. Scared us both so we turned around and went home. Rode around the
yard a bunch. Made a run across the neighbor's yard where I hadn't ridden before and
found that while I've gotten pretty good at handling 8-10" of powder 3 feet is a
totally different story...
Gotta go weld on the snowmobile trailer a little today, I managed to break the
trailer jack yesterday and one of the welds that holds the anti-tilt pin is
breaking. I need to turn up the heat on my welder and work on getting better
penetration which is hard when welding two different thicknesses. Might borrow
dad's stick welder in the spring, it'll put out more power than my mig.
-Curt
Time for a BIGGER MIG.
RB
_______________________________________
http://www.okiebenz.com
To search list archives http://www.okiebenz.com/archive/
To Unsubscribe or change delivery options go to:
http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
All posts are the result of individual contributors and as such, those
individuals are responsible for the content of the post. The list owner has no
control over the content of the messages of each contributor.
_______________________________________
http://www.okiebenz.com
To search list archives http://www.okiebenz.com/archive/
To Unsubscribe or change delivery options go to:
http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
All posts are the result of individual contributors and as such, those
individuals are responsible for the content of the post. The list owner has no
control over the content of the messages of each contributor.
