I’m probably going to go get a bolt extractor set and try that first. If not will cut it off and hope it will clear the bolt stub
Sent from my iPhone > On Jul 7, 2019, at 12:09 PM, Max Dillon via Mercedes <mercedes@okiebenz.com> > wrote: > > The axle should compress enough, if you cut off the bolt head. > > Open the differential and pull off the clip so you can take the whole stub > out? > -- > Max Dillon > Charleston SC > >> On July 7, 2019 12:55:22 PM EDT, Kaleb Striplin via Mercedes >> <mercedes@okiebenz.com> wrote: >> I’m in the process of removing a read axle in order to replace the rear >> wheel bearing. I have 5 of the 6 bolts out but of course 1 of them is >> buggered up. The way the bolts are in relation to the axle boot near it >> it is difficult to get a good solid grip on the without it slipping. If >> not very careful you will round it off. Any idea on how to proceed? I’m >> not sure I can just try cutting the head off because the axle must slip >> done from the diff. I don’t think there is enough room to pull it off >> the bolt stud then down. >> >> Sent from my iPhone >> >> _______________________________________ >> http://www.okiebenz.com >> >> To search list archives http://www.okiebenz.com/archive/ >> >> To Unsubscribe or change delivery options go to: >> http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com > > _______________________________________ > http://www.okiebenz.com > > To search list archives http://www.okiebenz.com/archive/ > > To Unsubscribe or change delivery options go to: > http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com > _______________________________________ http://www.okiebenz.com To search list archives http://www.okiebenz.com/archive/ To Unsubscribe or change delivery options go to: http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com