Then there is this one
http://www.baumtools.com/shop/Mercedes-Benz/33-Front-Axle/B129-0343-LOWER-WISHBONE-SUPPORT-JOINT-RR-TOOL#.Xb4yBtZ7ldg
On 11/2/2019 7:31 PM, Meade Dillon via Mercedes wrote:
This looks a little more palatable.
https://www.ebay.com/itm/VW-T4-Mercedes-Benz-W201-W124-Ball-joint-Press-Extractor-Tool-Outil-Tool-/331988806824
-------------
Max
Charleston SC
On Sat, Nov 2, 2019 at 5:41 PM Kaleb C. Striplin via Mercedes <
mercedes@okiebenz.com> wrote:
I am getting ready to do ball joints on a 201. I have done a 124 before
using the HF tool and some sections of cast iron pipe connections for
adapters. With this setup I got it done on the 124 years ago but it was
a pain in the ass. I have located the pipe pieces I used but in the
move I have no idea where the HF ball joint tool went to. I figure this
would be a good time to just get the proper one. So, with that said,
what is the proper tool? Car has about 180K on it, should I just pull
the control arms and replace the bushings also? That requires another
special tool to press those in and out?
--
This email has been checked for viruses by AVG.
https://www.avg.com
_______________________________________
http://www.okiebenz.com
To search list archives http://www.okiebenz.com/archive/
To Unsubscribe or change delivery options go to:
http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
_______________________________________
http://www.okiebenz.com
To search list archives http://www.okiebenz.com/archive/
To Unsubscribe or change delivery options go to:
http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
--
This email has been checked for viruses by AVG.
https://www.avg.com
_______________________________________
http://www.okiebenz.com
To search list archives http://www.okiebenz.com/archive/
To Unsubscribe or change delivery options go to:
http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
