See procedure 33-0440 in the FSM, picture of the tool 107-598-01-43-00. https://www.samstagsales.com/mbref.htm#201 has a couple of numbers (two for 201, one for 124, that say ball joint tool) but no pictures.
------------- Max Charleston SC On Sat, Nov 2, 2019 at 5:41 PM Kaleb C. Striplin via Mercedes < mercedes@okiebenz.com> wrote: > I am getting ready to do ball joints on a 201. I have done a 124 before > using the HF tool and some sections of cast iron pipe connections for > adapters. With this setup I got it done on the 124 years ago but it was > a pain in the ass. I have located the pipe pieces I used but in the > move I have no idea where the HF ball joint tool went to. I figure this > would be a good time to just get the proper one. So, with that said, > what is the proper tool? Car has about 180K on it, should I just pull > the control arms and replace the bushings also? That requires another > special tool to press those in and out? > > > -- > This email has been checked for viruses by AVG. > https://www.avg.com > > > _______________________________________ > http://www.okiebenz.com > > To search list archives http://www.okiebenz.com/archive/ > > To Unsubscribe or change delivery options go to: > http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com > > _______________________________________ http://www.okiebenz.com To search list archives http://www.okiebenz.com/archive/ To Unsubscribe or change delivery options go to: http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com