http://home.gwi.net/~craymond/CB900_tach_seal.jpg
Its hard to tell, its hard plasticy now but I would have figured it for rubber 20 years ago. I think for now I'm going to goop it with RTV superblack, put it together and hope. It only takes 20 minutes or so to take it apart if it leaks... -Curt Date: Tue, 13 May 2008 09:02:15 -0500 From: Loren Faeth <[EMAIL PROTECTED]> Subject: Re: [MBZ] was diesel, now Motorcycles for Bob/NOT! To: Mercedes Discussion List <mercedes@okiebenz.com> Message-ID: <[EMAIL PROTECTED]> Content-Type: text/plain; charset="us-ascii"; format=flowed are you talking about a gasket? I have never heard of a seal that isn't round! What shape is it? If it is a gasket, put some silicone form a gasket on it and slap it together. Or cut a gasket out of whatever material works best. FLAPS sell gasket material. At 08:52 AM 5/13/2008, you wrote: > > The problem is that it isn't round... > >Have you considered cutting one out of a sheet of Buna rubber? >(The stuff that inner tubes are made out of.) I've got about >a 1' square of the stuff I use for miscellaneous gasketry. >But one could also try a piece of dead inner tube. I also >got one of those free from Les Schwab when I needed a bigger >piece. It's a bit thinner than my sheet, too. > >-- Jim > > >_______________________________________ >http://www.okiebenz.com >For new parts see official list sponsor: http://www.buymbparts.com/ >For used parts email [EMAIL PROTECTED] > >To Unsubscribe or change delivery options go to: >http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com Loren Faeth _______________________________________ http://www.okiebenz.com For new parts see official list sponsor: http://www.buymbparts.com/ For used parts email [EMAIL PROTECTED] To Unsubscribe or change delivery options go to: http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com