I'd say the pinch welds.

-Bryan

--- On Wed, 3/11/09, Steve Kiffmeyer <[email protected]> wrote:
From: Steve Kiffmeyer <[email protected]>
Subject: Re: Suspension Rake effects
To: "Keith Tanner" <[email protected]>, "MiataPower" 
<[email protected]>
Date: Wednesday, March 11, 2009, 6:42 AM


RE: Suspension Rake effects
 
 

Where is the best place to measure the front vs 
rear underside height of the car....the 2 structural rails that run front 
to aft?

  ----- Original Message ----- 
  From: 
  Keith 
  Tanner 
  To: Steve Kiffmeyer ; MiataPower ; SSCOR 
  
  Sent: Wednesday, March 11, 2009 12:24 
  AM
  Subject: RE: Suspension Rake 
effects
  

  If you measure the underside of the chassis, you'll discover 
  that the 1/2" "rake" really isn't a rake at all. It's an artifact of the 
  fender design.

If you lift the rear, you'll bias the car more towards 
  oversteer/away from understeer.


-----Original Message-----
From: 
  [email protected] 
  on behalf of Steve Kiffmeyer
Sent: Tue 3/10/2009 5:42 PM
To: MiataPower; 
  SSCOR
Subject: Suspension Rake effects

I am getting ready to do some 
  major suspension overhauls on my 96 M-edition. Most folks have a higher lift 
  on the rear than the back(rake). I have always had my car even front to back. 
  About 12.25 inches wheel center to wheel arch.

Is there any difference 
  in handling with a rake versus no rake for 
  autocross?

Thanks

Steve

GC coil overs
KYB AGX 
  8-ways
FM rear shock extenders
15X6 stock wheels/ Toyo T1R 195/50/15 
  daily
15X7 /Kuhmo V710 205/50/15 autocross
FM 1 inch front anti-sway 
  bar
stock 11 mm rear anti sway bar
autocross and daily driving 
  only


_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower



      
_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

Reply via email to