That's what the Spec guys use.
 

Keith Tanner
Flyin' Miata
[email protected]
http://www.flyinmiata.com <http://www.flyinmiata.com/> 
1-800-FLY-MX5s (orders)
1-970-464-5600 (tech) 

 


________________________________

        From: [email protected]
[mailto:[email protected]] On Behalf Of Bryan Wyatt
        Sent: Wednesday, March 11, 2009 5:06 AM
        To: Miata Power List
        Subject: Re: Suspension Rake effects
        
        
I'd say the pinch welds.


-Bryan


--- On Wed, 3/11/09, Steve Kiffmeyer <[email protected]> wrote:


        From: Steve Kiffmeyer <[email protected]>
        Subject: Re: Suspension Rake effects
        To: "Keith Tanner" <[email protected]>, "MiataPower"
<[email protected]>
        Date: Wednesday, March 11, 2009, 6:42 AM
        
        
        Where is the best place to measure the front vs rear underside
height of the car....the 2 structural rails that run front to aft?

                ----- Original Message ----- 
                From: Keith Tanner <mailto:[email protected]>  
                To: Steve Kiffmeyer <mailto:[email protected]>  ;
MiataPower <mailto:[email protected]>  ; SSCOR
<mailto:[email protected]>  
                Sent: Wednesday, March 11, 2009 12:24 AM
                Subject: RE: Suspension Rake effects


                If you measure the underside of the chassis, you'll
discover that the 1/2" "rake" really isn't a rake at all. It's an
artifact of the fender design.
                
                If you lift the rear, you'll bias the car more towards
oversteer/away from understeer.
                
                
                -----Original Message-----
                From: [email protected] on behalf of
Steve Kiffmeyer
                Sent: Tue 3/10/2009 5:42 PM
                To: MiataPower; SSCOR
                Subject: Suspension Rake effects
                
                I am getting ready to do some major suspension overhauls
on my 96 M-edition. Most folks have a higher lift on the rear than the
back(rake). I have always had my car even front to back. About 12.25
inches wheel center to wheel arch.
                
                Is there any difference in handling with a rake versus
no rake for autocross?
                
                Thanks
                
                Steve
                
                GC coil overs
                KYB AGX 8-ways
                FM rear shock extenders
                15X6 stock wheels/ Toyo T1R 195/50/15 daily
                15X7 /Kuhmo V710 205/50/15 autocross
                FM 1 inch front anti-sway bar
                stock 11 mm rear anti sway bar
                autocross and daily driving only
                
                
                

        _______________________________________________
        Miatapower mailing list
        [email protected]
        http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower


_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

Reply via email to