Hi Jesse,
I have no need to replace the toe rails but my hatch boards are in sad shape. Mine
are plain plywood which have faded and warped.
The newer M-15s use a 1/2 inch hatch board. My older M-15 has a 3/8 inch hatch board.
Steve E. found a source of teak faced plywood in Maryland called Harbor Sales. They
have a two sided sliced teak 9.5 mm plywood that should work, item 489MSTAA.5
Link:
http://www.harborsales.net/
Look under Nautical & Marine for sliced teak.
The problem is, they sell plywood in 4 foot x 8 foot sheets. A sheet costs $168.
They are located 500 miles from me.
The overall size of the hatch is about 28 inches wide by 28 inches high. They will
cut the plywood into twelve pieces of approximately 12 inches high by 32 inches wide.
The cutting charge is $8. This would yield enough material to make four sets of hatch
boards, with the total dimension of each set being about 32 inches wide by 36 inches
high. The cost per set would be $44.
Would you or anyone else like to jointly purchase a sheet of plywood?
Steve R.
M-15 #119
Lexington, KY
--- message from "Jesse Tate" <[EMAIL PROTECTED]> attached:
--- Begin Message ---
|
Has anyone replaced their hatchboards and
toerails for an M15? Where did you find the replacements?
Thanks,
Jesse
|
_______________________________________________
http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats
--- End Message ---
_______________________________________________
http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats
