For those follow the progress of the boat fomerly know as Tonina, just thought 
I would let you that she is to finally get "wet". On the 17th she will be 
dragged to Anacortes, WA for a shake down cruse. She is not completed in every 
way as not all electronics are wired, the sides of her hull arent finished, nor 
is the fresh water or fuel systems complete...but hey there is always something 
to do, right?  Take care all!!  Rick
 
-----Original Message-----
From: [EMAIL PROTECTED]
To: [email protected]
Sent: Fri, 14 Apr 2006 14:36:58 -0400
Subject: Re: M_Boats: Internal Mast Plug


You know when I replaced the wires in the mast of my 17 I put long black 
ty-wraps (6") every 6-8 inches pointing in alternating directions and this kept 
the wires quiet, didn't allow moisture to collect and cause corrosion, and made 
removal a snap. Am doing the same currently w my M23 now (w longer wraps).
 
Rick 
M23 Raven
 #017
-----Original Message-----
From: Larry E Yake <[EMAIL PROTECTED]>
To: [email protected]
Sent: Thu, 13 Apr 2006 18:01:31 -0700
Subject: Re: M_Boats: Internal Mast Plug



On Wed, 12 Apr 2006 21:41:33 -0700 "Steve Shenkel" <[EMAIL PROTECTED]>
writes:
> I recently intended to put some foam pipe insulation over the 
> electrical
> cables inside the mast to keep them from slapping the inside of the 
> mast
> while at anchor.  About 4 feet into the bottom of the mast I ran 
> into
> something hard.  An inspection with a flashlight revealed a bird's 
> nest.
> However, after removing it a hard plug remained.
>  
> Is this common (in Montgomery Mast's), or perhaps was this the PO's 
> attempt
> at a similar fix?

There was no plug inside Tullamore's mast.  I filled it with those
Styrofoam packing peanuts to keep the wires from rattling, and then
plugged the ends with pieces from a swim noodle. Perfect fit, and extra
floatation if the worst happens.

Larry

_______________________________________________
http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats
_______________________________________________
http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats
_______________________________________________
http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats

Reply via email to