Thank you first.
I use external 8 MHz crystal in LXT1. I want keep the smclk active so that
the ADC, timerB can work in the low power mode, Does the LPM3 can meet these
requirements? I think in LPM3, the SMCLK is disabled, right?
Also, I have a question about coming back out of LPM3 mode(
_BIC_SR_IRQ(LPM3_bits);. If an interrupt is generated, can it automaticly
comes back out of LPM3 mode , or if I need to write code
_BIC_SR_IRQ(LPM3_bits) to pull the MCU out of LPM?
Thanks
Gao
----- Original Message -----
From: <[email protected]>
To: <[email protected]>
Sent: Tuesday, January 18, 2005 6:26 PM
Subject: Re: [Mspgcc-users] about low power mode
Hi,
I am new in mspgcc, can someone please tell me how can I put
microcontroller
into LPM1 mode. Does following code works?
LPM1 does not make much sense. In most cases you do need LPM3.
In the code examples from TI i only found LPM3 and in the
examples from mspgcc LPM3 and LPM4.
I think i've seen some code with LPM1 and LPM2 on a conferece from TI.
LPM1 and LPM2 should work if you replace the string "LPM3" by
"LPM1" or rather "LPM2" in the examples.
Regards,
Rolf
-------------------------------------------------------
The SF.Net email is sponsored by: Beat the post-holiday blues
Get a FREE limited edition SourceForge.net t-shirt from ThinkGeek.
It's fun and FREE -- well, almost....http://www.thinkgeek.com/sfshirt
_______________________________________________
Mspgcc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/mspgcc-users
