2.6.13-1.1532_FC4We need more information about your system: Which kernel are you using? If you are not using the DVB driver for the HD3000, well..., you should be! Note that I haven't rebooted when working on this. I just: /sbin/modprobe cx88-dvb and the modules load. However, I just rebooted and I had to manually: /sbin/modprobe cx88-dvb to get the modules to load (so that /dev/dvb/adapter0 would be created.) Don't know why. But, that should be a separate problem,right. Here's modprobe.conf: alias char-major-61 lirc_i2c alias eth0 via-rhine alias scsi_hostadapter sata_via alias snd-card-0 snd-via82xx options snd-card-0 index=0 options snd-via82xx index=0 remove snd-via82xx { /usr/sbin/alsactl store 0 >/dev/null 2>&1 || : ; }; /sbin/modprobe -r --ignore-remove snd-via82xx alias usb-controller ehci-hcd alias usb-controller1 uhci-hcd alias ieee1394-controller ohci1394 # # ivtv modules setup alias char-major-81-0 ivtv alias tveeprom tveeprom-ivtv alias msp3400 msp3400-ivtv # # nvidia kernel module alias char-major-195 nvidia-1_0-7676 alias nvidia nvidia-1_0-7676 # lirc - at bottom to ensure ivtv is loaded before lirc_i2c install lirc_i2c /sbin/modprobe ivtv; /sbin/modprobe --ignore-install lirc_i2c install cx88-dvb /sbin/modprobe cx8800;/sbin/modprobe --ignore-install cx88-dvb Yes. here is (relevant) dmesg at bootup (too long to include all):Why is this of interest...well there could be some conflict between the two cards and/or between the IVTV software and the kernel modules. There just isn't enough information in your post to be sure. ---------------------------------------- Linux version 2.6.13-1.1532_FC4 ([EMAIL PROTECTED]) (gcc version 4.0.1 20050727 (Red Hat 4.0.1-5)) #1 Thu Oct 20 01:30:08 EDT 2005 <snip> shpchp: Standard Hot Plug PCI Controller Driver version: 0.4 Linux video capture interface: v1.00 cx2388x blackbird driver version 0.0.5 loaded cx88[0]: subsystem: 7063:3000, board: pcHDTV HD3000 HDTV [card=22,autodetected] TV tuner 52 at 0x1fe, Radio tuner -1 at 0x1fe cx2388x v4l2 driver version 0.0.5 loaded ACPI: PCI Interrupt 0000:00:0b.0[A] -> Link [LNKC] -> GSI 11 (level, low) -> IRQ 11 cx88[0]: subsystem: 7063:3000, board: pcHDTV HD3000 HDTV [card=22,autodetected] TV tuner 52 at 0x1fe, Radio tuner -1 at 0x1fe cx88[0]/0: found at 0000:00:0b.0, rev: 5, irq: 11, latency: 32, mmio: 0xea000000 : chip found @ 0xc2 (cx88[0]) tuner 1-0061: type set to 52 (Thomson DDT 7610 (ATSC/NTSC)) cx88[0]/0: registered device video0 [v4l2] cx88[0]/0: registered device vbi0 cx88[0]/0: registered device radio0 ivtv: ==================== START INIT IVTV ==================== ivtv: version 0.4.0 (tagged release) loading ivtv: Linux version: 2.6.13-1.1532_FC4 686 REGPARM 4KSTACKS gcc-4.0 ivtv: In case of problems please include the debug info ivtv: between the START INIT IVTV and END INIT IVTV lines when ivtv: mailing the ivtv-devel mailinglist. ivtv0: Autodetected WinTV PVR 250 card (iTVC16 based) ACPI: PCI Interrupt 0000:00:0a.0[A] -> Link [LNKB] -> GSI 11 (level, low) -> IRQ 11 ivtv0: Unreasonably low latency timer, setting to 64 (was 32) ivtv0: i2c attach to card #0 ok [client=tveeprom, addr=50] : chip found @ 0xc2 (ivtv i2c driver #0) ivtv0: i2c attach to card #0 ok [client=(tuner unset), addr=61] tveeprom: Hauppauge: model = 32062, rev = B185, serial# = 7366797 tveeprom: tuner = TCL 2002N 6A (idx = 85, type = 50) tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000) tveeprom: audio_processor = MSP3445 (type = 12) saa7115 2-0021: saa7115 found @ 0x42 (ivtv i2c driver #0) ivtv0: i2c attach to card #0 ok [client=saa7115, addr=21] msp34xx: ivtv version msp34xx: init: chip=MSP3445G-B8, has NICAM support, simple (D) mode, simpler (G) no-thread mode msp34xx: $Id$ compiled on: Oct 21 2005 02:12:13 ivtv0: i2c attach to card #0 ok [client=MSP3445G-B8, addr=40] tda9885/6/7: chip found @ 0x86 ivtv0: loading /lib/modules/ivtv-fw-enc.bin ivtv0: Encoder revision: 0x02040024 ivtv0 warning: Encoder Firmware can be buggy, use version 0x02040011 or 0x02050032. ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total) ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total) ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total) ivtv0: Create encoder radio stream tuner 2-0061: type set to 50 (TCL 2002N) ivtv0: Initialized WinTV PVR 250, card #0 ivtv: ==================== END INIT IVTV ==================== ---------------------------------------- |
_______________________________________________ mythtv-users mailing list mythtv-users@mythtv.org http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users