Ok Ike , thanks alot for your help , Ill try replacing the op-amp first and go from there.
-Brian --- On Tue, 1/6/09, Ike Zimbel <[email protected]> wrote: > From: Ike Zimbel <[email protected]> > Subject: Re: NEOTEK: problem with my Neotek Elan II > To: [email protected] > Date: Tuesday, January 6, 2009, 3:34 PM > Ok, that could potentially be IC # U-4 on the master module. > It's an NE-5532 dual op-amp, 8 pin DIP package. It's > socketed so you should be able to pry it out with a little > screw driver and put the new one in. MAKE SURE you put it in > the right way up (the dot or notch on the end should face > the top of the module) That would be the master module, BTW, > the chip should be right under the "Aux A" master > pot. If you are not sure what you are doing, get help. Also, > make sure that all eight pins of the IC go into the socket > and don't bend under it or outside it. AND, be advised > that it could be other components besides the chip, like > R-14, R-15 (both 47r, 1/4 watt) or C-103, 47uf/25v Bi-polar. > best, > Ike > > Brian Simmons wrote: > > Hi ! > > Thanks alot for your quick reply ! > > > > It seems to be the same for all the channels. > > > > -Brian > > > > > > --- On Tue, 1/6/09, Ike Zimbel > <[email protected]> wrote: > > > > > >> From: Ike Zimbel <[email protected]> > >> Subject: Re: NEOTEK: problem with my Neotek Elan > II > >> To: [email protected] > >> Date: Tuesday, January 6, 2009, 2:33 PM > >> Hi Brian, > >> Is this on a per channel basis, or right > across the > >> board? If it is individual channels, it is > probably a bad solder joint on > >> the pan pot. This is really common on the Elite > and may also happen on > >> the Elan. > >> best, > >> Ike > >> > >> Brian Simmons wrote: > >> > >>> I bought a Neotek Elan II about 3 years ago > and have > >>> > >> run into a problem with my Aux A/B section. When I > pan the > >> individual channel Aux A/B to the right I get a > full sinal > >> out of "B" but if I pan to the left , I > get a very > >> low level signal that sounds a bit distorted out > of > >> "A". When I solo the master send for > "A" > >> its the same low level distorted signal. > >> > >>> I have very little experience in electronics > so any > >>> > >> help would be greatly appreciated. > >> > >>> thanks > >>> -Brian > >>> > >>> > >>> > >>> > >>> > >>> ------ > >>> > >>> You can unsubscribe at anytime by sending an > email to > >>> > >> mailto:[email protected] with > "unsubscribe > >> neotek" in the message body. If you have any > >> difficulties, or questions --please send an email > to > >> [email protected]. > >> > >>> The Neotek list is lovingly hosted by > Catapult Web > >>> > >> Development. Remember that any message or reply > sent to the > >> list will be automatically forwarded to all > subscribers. > >> > >>> Vive Le Neotek ! > >>> > >>> Thanks. > >>> > >>> > >> -- Ike Zimbel > >> Zimbel Audio Productions Ltd. > >> Toronto > >> 416-720-0887 > >> "Studio House Calls" - Repairs and > upgrades to > >> analog audio equipment including: Amek, Allen > & Heath, > >> Neve, Neotek, MCI, Soundcraft and more. > >> > >> > >> ------ > >> > >> You can unsubscribe at anytime by sending an email > to > >> mailto:[email protected] with > "unsubscribe > >> neotek" in the message body. If you have any > >> difficulties, or questions --please send an email > to > >> [email protected]. > >> > >> The Neotek list is lovingly hosted by Catapult > Web > >> Development. Remember that any message or reply > sent to the > >> list will be automatically forwarded to all > subscribers. > >> Vive Le Neotek ! > >> > >> Thanks. > >> > > > > > > ------ > > > > You can unsubscribe at anytime by sending an email to > mailto:[email protected] with "unsubscribe > neotek" in the message body. If you have any > difficulties, or questions --please send an email to > [email protected]. > > > > The Neotek list is lovingly hosted by Catapult Web > Development. Remember that any message or reply sent to the > list will be automatically forwarded to all subscribers. > > Vive Le Neotek ! > > > > Thanks. > > > > > > -- Ike Zimbel > Zimbel Audio Productions Ltd. > Toronto > 416-720-0887 > "Studio House Calls" - Repairs and upgrades to > analog audio equipment including: Amek, Allen & Heath, > Neve, Neotek, MCI, Soundcraft and more. > > > ------ > > You can unsubscribe at anytime by sending an email to > mailto:[email protected] with "unsubscribe > neotek" in the message body. If you have any > difficulties, or questions --please send an email to > [email protected]. > > The Neotek list is lovingly hosted by Catapult Web > Development. Remember that any message or reply sent to the > list will be automatically forwarded to all subscribers. > Vive Le Neotek ! > > Thanks. ------ You can unsubscribe at anytime by sending an email to mailto:[email protected] with "unsubscribe neotek" in the message body. If you have any difficulties, or questions --please send an email to [email protected]. The Neotek list is lovingly hosted by Catapult Web Development. Remember that any message or reply sent to the list will be automatically forwarded to all subscribers. Vive Le Neotek ! Thanks.
