hey kyle... ok so this sounds like the exact same setup i'm envisioning... i.e. running the dyns full range and filling in the bottom with the sub. so when you say "passive split" off the mon. A outs... are you literally wiring the sub right off the same terminals that the hafler is fed with?
thanks bro. p On Feb 20, 2012, at 1:39 PM, Kyle Mann wrote: > Pete, > > I'm using a Velodyne VA-1215X in conjunction with my ProAc Studios (powered > by a Hafler 9505). The Velodyne does have a speaker-thru, but since I wanted > to run the monitors full-range and use the sub to fill in the 20-50Hz area, > I'm simply using a passive split off the Monitor A outs of my Series 1E. No > problems whatsoever. > > Kyle > > On Monday, February 20, 2012, pete wrote: > quick question for the list... > > i have a cheap-o active sub i'd like to integrate into my series IIIc here > (just to get a basic idea of subsonic junk going on in mixes) and am > wondering the best and or easiest way to go forward. > adding the sub in parallel with say the speaker A outs (on which there is a > set of active Dynaudio bm6a) effectively lowering the input imp. seen by the > master module i take it is not the way to go.... > my initial thought is to take a line out of the 2-mix #3 in the patchbay and > send that to the sub... i really wanted to be able to switch it out though > when i am on the smaller avantone monitors on speaker select A. > > any tips from people using subs on their older neotek setups? > > thanks!! > > pete------ > > View the list online at: http://www.mail-archive.com/[email protected] > > You can unsubscribe at anytime by sending an email to > mailto:[email protected] with "unsubscribe neotek" in the message body. > If you have any difficulties, or questions --please send an email to > mailto:[email protected]. > > The Neotek list is lovingly hosted by Catapult Web. Remember that any message > or reply sent to the list will be automatically forwarded to all subscribers. > > Vive Le Neotek! > > Thanks.
