Correct. However, my console was configured with 1/4" i/o on the back, so it's simply a Y split — one going to the amp, one to the sub.
On Monday, February 20, 2012, pete wrote: > hey kyle... > > ok so this sounds like the exact same setup i'm envisioning... i.e. > running the dyns full range and filling in the bottom with the sub. so when > you say "passive split" off the mon. A outs... are you literally wiring the > sub right off the same terminals that the hafler is fed with? > > thanks bro. > > p > > On Feb 20, 2012, at 1:39 PM, Kyle Mann wrote: > > Pete, > > I'm using a Velodyne VA-1215X in conjunction with my ProAc Studios > (powered by a Hafler 9505). The Velodyne does have a speaker-thru, but > since I wanted to run the monitors full-range and use the sub to fill in > the 20-50Hz area, I'm simply using a passive split off the Monitor A outs > of my Series 1E. No problems whatsoever. > > Kyle > > On Monday, February 20, 2012, pete wrote: > >> quick question for the list... >> >> i have a cheap-o active sub i'd like to integrate into my series IIIc >> here (just to get a basic idea of subsonic junk going on in mixes) and am >> wondering the best and or easiest way to go forward. >> adding the sub in parallel with say the speaker A outs (on which there is >> a set of active Dynaudio bm6a) effectively lowering the input imp. seen by >> the master module i take it is not the way to go.... >> my initial thought is to take a line out of the 2-mix #3 in the patchbay >> and send that to the sub... i really wanted to be able to switch it out >> though when i am on the smaller avantone monitors on speaker select A. >> >> any tips from people using subs on their older neotek setups? >> >> thanks!! >> >> pete------ >> >> View the list online at: >> http://www.mail-archive.com/[email protected] >> >> You can unsubscribe at anytime by sending an email to mailto: >> [email protected] with "unsubscribe neotek" in the message body. >> If you have any difficulties, or questions --please send an email to mailto: >> [email protected]. >> >> The Neotek list is lovingly hosted by Catapult Web. Remember that any >> message or reply sent to the list will be automatically forwarded to all >> subscribers. >> >> Vive Le Neotek! >> >> Thanks. >> > >
