Anne Wilson wrote: >On Sunday 13 Oct 2002 3:52 pm, you wrote: > > >>Smiley wrote: >> >> >>>On Sat, 12 Oct 2002 20:33:00 -0500 >>> >>>Linus Drouhard <[EMAIL PROTECTED]> wrote: >>> >>> >>>>I finally did the obvious and reinstalled 9.0. That fixed my printing >>>>problem. I may never know what the problem was (and really won't care as >>>>long as it doesn't happen again.) I really wanted to discover the >>>>problem and "fix" it rather just a clean install, but, as someone else >>>>mentioned, "not having printing is a show stopper." Good luck to >>>>everyone else still struggling with printing. >>>> >>>> >>>I'm having same trouble with Stylus Photo 810 on USB; what happen, I only >>>discovered using WWWCups, is that for some reason at a certain point the >>>OS doesn't "see" the USB device anymore and stop printing... but the work >>>is still qeued, and I have to delete that work; after that I "stop" and >>>then "start" again printer and the printer could start new works... but >>>then it stops again >>> >>>:D >>> >>>Previously parallel prto didn't work, also; but with M 8.2 now is all >>>okay... For parallel port perhaps it was only a matter of upragde. >>> >>>Smiley >>> >>> >>My usb printer is often falling out of USB hub view, so reluctantly I >>have to >>reboot for mandrake to find it again which annoys me. There ought to >>be a command that would tell the OS to redetect it again, to save >>time and effort. >> >>John >> >> > >Just as a matter of interest - are these problems occurring on usb devices >joined to the motherboard, to hubs, or both? > >Anne > > > > Well, I'm not entirely sure I understand the question. I have 8 USB ports , a bank of the usual 2 and a bank of 6, 2 are physically attatched to the mobo, ported to the rear, 6 are on a rack and cable plugged to the mobo, ported to the rear.
As far as the usb hub is concerned they show up as 4 entries in the kde -info-USB devices, like so, USB OHCI Root Hub |____ Lexmark Z53 printer USB OHCI Root Hub USB OHCI Root Hub USB OHCI Root Hub every now and again the printer drops out of recognition and so I reboot which brings it back again, sometimes , modprobe usb-ohci in a root terminal works, sometimes it does not. This happens in M8.2 , and was the norm from first boot on M9.0 beta2 I never got any futher than that as far as the later betas are concerned. Basically USB detection of my usb printer is erratic. I suppose I should mention that the 8 usb ports on my msi mobo are both usb1 and usb2 , at least 4 of them can be usb2, I don't believe mandrake configures any of them usb2 though. John -- John Richard Smith [EMAIL PROTECTED]
Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com