Hello
I have installed "The Complete LINUX OPERATING SYSTEM 6.0" on my computer
using the "Wortstation" class, but there are problems. The Linux cannot
detect my LS-120 super drive. Below are the messages occurred during the
system boot up:
.
. (other messages here)
.
hdd: ,ATAPI UNKNOWN (type 31) drive
.
. (other messages here)
.
/dev/hdd: device not configured
[FAILED]
.
. (other messages here)
.
Also if I add the line "vga=normal" in the file "lilo.conf", an error
message "VGA mode presetting is not supported by your kernel." will occur
after I run "/sbin/lilo". I thought my kernel's settings was not
appropriate, so I reconfigured my kernel, with the options "Include
IDE/ATAPI FLOPPY support" and "Video mode selection support" enabled, then
recompiled my kernel. But after all these the above two problems still
exist.
The steps I have taken to compile the kernel are listed below.
1. Install all "devel" packages.
2. Install the kernel source.
3. Change to "/use/src/linux" and "make mrproper".
4. "make xconfig" and configured the settings
5. "make dep;make clean;make bzImage"
6. Copy "bzImage" to "/boot"
7. Copy "System.map" to "/boot"
8. Edit "/etc/lilo.conf"
9. Run "/usr/sbin/lilo"
10. Reboot
Can anyone help me??
______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com