On Monday 05 Jan 2004 8:07 am, Merlin Zener wrote:
> On Mon, 2004-01-05 at 06:45, Derek Jennings wrote:
> > [...snip]
> >
> > The line "PING 169.254.5.217 (169.254.5.217) from 203.146.175.77 "
> > means your Mandrake desktop is trying to reach your Windows box via a
> > different subnet. Either because the Ethernet on the Mandrake box is not
> > configured correctly, or because your route table is incorrect.
> >
> > What do you see if you do
> > 'ifconfig'   and 'route'
>
> Thanks [yet again] for your answer, Derek.
>
> Here's the results: I must confess it means *nothing* to me...
>
> [EMAIL PROTECTED] merlin]# ifconfig
> lo        Link encap:Local Loopback
>           inet addr:127.0.0.1  Mask:255.0.0.0
>           UP LOOPBACK RUNNING  MTU:16436  Metric:1
>           RX packets:75 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:75 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:0
>           RX bytes:11908 (11.6 Kb)  TX bytes:11908 (11.6 Kb)
>
> ppp0      Link encap:Point-to-Point Protocol
>           inet addr:203.146.33.130  P-t-P:203.146.173.199
> Mask:255.255.255.255
>           UP POINTOPOINT RUNNING NOARP MULTICAST  MTU:1514  Metric:1
>           RX packets:297 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:342 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:3
>           RX bytes:207945 (203.0 Kb)  TX bytes:19008 (18.5 Kb)
>
> [EMAIL PROTECTED] merlin]# route
> Kernel IP routing table
> Destination     Gateway         Genmask         Flags Metric Ref    Use
> Iface
> nas-cbilf2.loxi *               255.255.255.255 UH    0      0        0
> ppp0
> 127.0.0.0       *               255.0.0.0       U     0      0        0
> lo
> default         nas-cbilf2.loxi 0.0.0.0         UG    0      0        0
> ppp0
> [EMAIL PROTECTED] merlin]#
>
>
> --
> Merlin Zener
> Piano, Synthesizer
> Thailand.
>
> registered Linux user number 328618

Well it tells me that you only have a dial up connection. Your Eth0 interface 
is not there.
Have you tried going through the wizard in drakconnect?
Is the correct driver being loaded? Is there a line starting
"alias eth0" in the /etc/modules.conf file?
What make of ethernet interface is this?


derek


-- 
----------------------------------
www.jennings.homelinux.net
http://twiki.mdklinuxfaq.org


Want to buy your Pack or Services from MandrakeSoft? 
Go to http://www.mandrakestore.com

Reply via email to